Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card connector.
2. Slide the solid-state drive into the M.2 card connector on the system board.
3. Replace the single (M1.2x1.5) screw to secure the solid-state drive to the system board.
4. Align and place the solid-state drive shielding cover, press to fit it firmly to cover the solid-state drive.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Wireless Wide Area Network (WWAN) Card
Removing the WWAN card
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
After working inside your
Before working inside your
computer.
computer.
Before working inside your
Removing and installing components
17