Table of Contents
Advertisement
SATA6G_1(Charcoal Black) - SATA6G_6(Charcoal Black)
SATA6G_1(Charcoal Black) - SATA6G_6(Charcoal Black)
This item allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
Hot Plug
These items appears only when the SATA Mode Selection is set to [AHCI] and allows
you to enable or disable SATA Hot Plug Support.
Configuration options: [Disabled] [Enabled]
3.6.6
PCH-FW Configuration
This item allows you to configure the firmware TPM.
3.6.7
Onboard Devices Configuration
The items in this menu allow you to switch between PCIe Lanes and configure onboard
devices.
Hyper M.2X16 [Enabled][Disabled]
[Disabled]
[Enabled]
The number of SSDs that can be detected varies with the configurations of the PCIe X16
slots.
HD Audio Controller
This item allows you to use the Azalia High Definition Audio Controller.
Configuration options: [Disabled] [Enabled]
M.2_1 Configuration: [Auto][SATA mode][PCIE mode]
[Auto]
[SATA mode]
[PCIE mode]
M.2_2 PCIe Bandwidth Configuration: [X2][X4]
[X2]
[X4]
RGB LED lighting
This item allows you to turn the RGB LED lighting on or off.
Configuration options: [Off] [On]
3-18
Only one SSD installed onto the Hyper M.2 X16 card can be detected.
Two or three SSDs installed onto the Hyper M.2 X16 card can be detected.
Auto-detects the M.2 device mode. If a SATA device is detected,
SATA6G_1 will be disabled.
Only supports M.2 SATA devices. Please note that SATA6G_1 port cannot
be used in this mode.
Only supports M.2 PCIE devices.
Run at X2 mode with SATA6G_56 enabled.
Run at X4 mode for higher performance with SATA6G_56 disabled.
Chapter 3: BIOS Setup
Hide quick links:
Advertisement
Table of Contents
