Royal R-3500TR Installer's Manual page 45

VARIABLE SPEED CONTROL
BLK
BLK
BLK
BLK
TEMPERATURE
SENSOR SWITCH
JUNCTION BOX
FAN
Figure 40. Fan Wiring Diagram
NOTE
CAUTION
JUNCTION BOX
BLK
BLK
BLK
WHT
WHT
BLK
GROUND
GRN
BLK
WHT
110-120 VAC
For Direct Spark Ignition (DSI) Wiring
Appliance Requirements
This appliance requires that 110-120 VAC be
wired to the junction box included in the manual
bag assembly. Maintain correct polarity when
wiring the junction box.
The junction box is installed by sliding one tab of
the box through the slot on the lower right side of
the outer wrap and driving a screw through the
other tab into the pilot hole on the outer wrap.
Optional Accessories
Optional fan and remote control kits require that
110-120 VAC be wired to the fireplace junction box.
Remote Wall Switch
Position the remote wall switch in the desired position
on a wall. Run 16 A.W.G. minimum Romex wire and
connect it to the fireplace ON/OFF switch pigtails.
Electrical wiring must be installed by a licensed electrician.
LABEL ALL WIRES PRIOR TO DISCONNECTION
WHEN SERVICING CONTROLS. WIRING ER-
RORS CAN CAUSE IMPROPER AND DANGER-
OUS OPERATION. VERIFY PROPER OPERA-
TION AFTER SERVICING.
NOTE: IF ANY OF THE ORIGINAL WIRE
AS SUPPLIED WITH THE APPLIANCE
MUST BE REPLACED, IT MUST BE
O
REPLACED WITH TYPE 105 C RATED WIRE.
BLOWER RECEPTACLE
BLOWER
TEMPERATURE
SENSOR SWITCH
SPEED CONTROL
(RHEOSTAT)
45