Installing Vent Components - Royal R-3500TR Installer's Manual

30
B. Installing Vent Components
After determining which set of starting collars will be used
(top or rear), follow venting instructions accordingly.
Venting Out the Rear Vent
Remove the installed rear seal cap from the rear starting
collars by cutting the strap at each end. (See Figure 24)
Remove the insulation inside the 5” collar. (See Figure 24).
Follow the vent configuration tables accordingly.
Remove the 5” diameter disk in the center of the REAR heat
shield by twisting the disk and breaking it out. This can be
done from inside the firebox or by reaching through the vent.
! WARNING: THE TOP HEAT SHIELD (INSIDE
THE FIREBOX) MUST REMAIN ATTACHED IF
THE VENT SYSTEM IS ATTACHED TO THE REAR
STARTING COLLARS. SEE FIGURE 24.
In models R-3500TRH and R-4500TRH, the disk may
be difficult to twist and break. Remove the exhaust
shield and rear heat shield. Replace the exhaust shield.
Venting Out the Top Vent
Remove the top vent collar seal cap by cutting the strap at
each end. (See Figure 24). Remove the insulation inside
BOTH collars. (See Figure 24). Next remove the glass door.
Remove the 4” diameter disk in the center of the TOP heat
shield by twisting the disk and breaking it out. This can be
done from inside the firebox or by reaching through the vent.
You have to take the glass off again for positioning the logs
when the unit is finally installed in place and finished
around it. Re-install the glass door. Attach vent system to
the top starting collars.
WARNING: THE REAR VENT COLLAR SEAL
!
CAP MUST REMAIN ATTACHED TO THE
REAR VENT COLLARS IF THE VENT SYS-
TEM IS ATTACHED TO THE TOP STARTING
COLLARS. SEE FIGURE 24.
WARNING: FAILURE TO REMOVE INSULA-
!
TION IN THE SET OF COLLARS YOU ARE
USING COULD CAUSE A FIRE.
WARNING: YOU MUST LEAVE THE INSULA-
!
TION IN PLACE IN THE SET OF COLLARS
YOU ARE NOT USING.
Venting Out Rear
Insert screwdriver
or similar object
here to remove cap.
CUT HERE
Figure 24
Venting Out Top