International comfort products R9MSB0801716 Installation Instructions Manual page 15

INSTALLATION INSTRUCTIONS
Remove plug from
collector box.
DO NOT DISCARD.
NOTE: Remove knockout in
casing before re installing the
condensate trap.
Attach condensate
trap with screw to
collector box.
Install plug on
open port of
collector box
440 01 6001 05
Unconverted Factory Configuration
As Viewed in the Horizontal Right Orientation
Horizontal Right Trap Configuration
Figure 10 − Horizontal Right Trap Configuration
(Appearance may vary)
Specifications subject to change without notice.
Gas Furnace: R9MSB
If alternate vent position
is required, loosen clamp
on inlet of vent elbow.
Remove the screw that secures
the trap to the collector box and
remove trap.
Slide relief tube in stand offs
to adjust length.
Vent elbow shown in alternate
orientation. Tighten clamp on
inlet to vent elbow 15 lb. in.
Align trap over middle and
right hand port on collector box.
A11573
15