Advertisement
SPRAYING
Plug turbine power cord
into grounded outlet.
Point gun towards a free area. Evacuate air
from FlexLiner™ System by holding gun
vertically and pulling trigger until
continuous spray pattern is achieved.
CLEANING
Disconnect gun from
FlexLiner™ System.
STANDARD
Connect gun to air hose.
Turn power switch to ON position.
Point gun towards free area.
Pull trigger and flush gun.
If necessary refill cup.
Repeat process till liquid runs clear.
OPTIONAL ARTISAN AIR VALVE
Remove air plug housing.
INsert Artisan air valve.
HVLP EDGE™ II gun only.
GRACO DISTRIBUTION BVBA Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
Tel: +32 (89) 770 700 • Fax: +32 (89) 770 777
www.graco.com
STANDARD
PROCONTRACTOR
Turn power switch to:
START > STANDARD VERSION
AUTOSTART > PROCONTRACTOR VERSION
Turn TURBO CONTROL
to maximum.
Aim center of spray gun at bottom
edge of previous stroke, overlapping
half of each stroke. To optimise
atomisation, adjust air control knob.
To optimise product flow,
adjust fluid control.
1
2a
2
3
4
5
Clean all parts well, using
a new FlexLiner™ if
UNscrew ring and lid from cup.
PROCONTRACTOR
Remove retaining ring and air cap.
Clean all parts well with cleaning agent.
Re-insert gun after cleaning.
The right is reserved to make changes at any time without notice. For more information on Graco's intellectual property, see www.graco.com/patent or www.graco.com/trademarks.
Set fluid control
dial to #5.
UNEVEN FINISH
EVEN FINISH
THICK
EVEN
THIN
EVEN FINISH
UNEVEN FINISH
THIN
THICK
THIN
If atomisation is too coarse, use
finer fluid set or dilute
the product with
recommended agent.
Fill FlexLiner™ in cup with cleaning agent,
cover cup valve and shake well.
possible.
Repeat until parts are clean.
Wipe hose gun and cup
with rag soaked in water or
mineral spirits.
© 2018 GRACO Distribution BVBA · Form No. 328034ENEU (revB)· 08/18 · Digital version only.
All information, illustrations, and specifications in this document are based on the latest product information available at the time of publication.
PROCONTRACTOR ONLY
Rotate pattern size
control clockwise to
Set air control.
maximum fan diameter.
STANDARD
PROCONTRACTOR
FlexLiner™ from
Turn off turbine.
gun to refill cup
Fill cup with cleaning
agent and connect
FlexLiner™ sytem to gun.
STANDARD
PROCONTRACTOR
Turn off turbine.
Graco is certified ISO 9001.
Disconnect
Advertisement
