Dimplex CXD2000VE Instruction Manual page 4

Cable Installation
Remove the two screws which hold the plastic terminal cover box (A) in place,
lift off the terminal cover box and set aside with the two screws for future use.
Remove the two screws securing the cable saddle clamp (B) and also set them
safely aside for future use.
Set the end of the power supply cable into position on the clamp (C) and strip
a suitable length of cable sheath off the end of the power supply cable so that
Live, Neutral and Earth wires are a suitable length to fit between the clamp (C)
and the screw fixing locations in the termial block provided (D) as shown.
Strip the ends of the Live, Neutral and Earth wires and fit each end under the
protector plates of the terminal block. Ensure the terminal screws are tight and
the wires are clamped securely by the terminal screws.
Place the end of the power supply cable sheath onto the the clamp (C). Refit
and tighten the cable saddle clamp (B) securely on top using the two screws
previously removed.
Refit the terminal cover box (A) to the base moulding using the two screws
previously removed.
Ensure the power supply cable when fitted does not make contact with the body
of the heater.
Commissioning
• Checks on the electrical installation should include earth continuity and insulation
tests and must be undertaken by a competent person.
• Ensure that all the electrical connections at the lamps and the terminal blocks
have been made correctly, that they are tight and that there is no loose or frayed
wire.
• Replace and secure the terminal cover box and replace and secure the front panel.
• Check that the mounting bracket is securely fixed in the vertical position such
that the lamps remain in a horizontal plane at all angles of heater displacement.
• Roughly align the heater(s) and tighten the adjusters.
• Switch on the heater(s) and check that the lamp(s) are all operating. If time or
temperature controls are fitted check these for correct and safe operation by
reference to the supplier's instructions.
• Make any adjustments that are necessary to give an even spread of heat over the
required area. This may be done simply by perception of the heating effect or
by using the distribution of visible light either at night or by darkening the room.
Hand over
Hand over these instructions and make sure the user is familiar with all aspects
of operation and safety including the need for regular cleaning and an annual
inspection. In the event of the premises being unoccupied then leave heater(s)
switched off and isolated from the electrical supply. Leave instructions adjacent to
the electricity meter.
4
(see Fig 1 & 2)