Daewoo DWD-HD94A2 Service Manual page 32

MESSAGE ERROR
The water tap is closed.
The filter of the valve inlet is clogged.
The valve inlet is an inferior product or broke down.
WATER INLET
IE
The water level sensor (sensor pressure) is an inferior product
ERROR
or broke down.
The drain motor works during water supply.
The PCB ASS'Y does not check the water level.
The drain hose is kinked or clogged.
The drain motor is an inferior product.
DRAIN
OE The valve inlet works during drain.
ERROR
The water level sensor is an inferior product.
The PCB ASS'Y does not check the water level.
UNBALANCE
UE
The laundry is concentrated to one side of the drum during spin. Rearrange the laundry.
ERROR
The Start/Pause button is pressed while the door is opened.
DOOR OPEN
LE
The switch door lock is an inferior product.
ERROR
The PCB ASS'Y does not check the door lock.
The water is supplied continuously due to an inferior valve inlet.
The valve inlet is normal, but the water level sensor
OVERFLOW
E2
(sensor pressure) is inferior.
ERROR
The drain motor does not work.
(The drain motor is an inferior product or broke down.)
Water leaks from the tub or the hose drain.
LEAKAGE
E4
ERROR
The laundry is jammed between the gasket and the drum.
HIGH VOLTAGE
E5
ERROR
The PCB ASS'Y is an inferior product.
The laundry is jammed between the gasket and the drum.
E6
EMG ERROR
The motor is an inferior product.
The PCB ASS'Y is an inferior product.
The motor is not normally connected.
MOTOR
The motor does not work.
E8
ERROR
(The motor is an inferior product or broke down.)
SENSOR
E9
The water level sensor is an inferior product.
PRESSURE ERROR
The thermistor wash is an inferior product or broke down.
THERMISTOR
H2
WASH ERROR
The thermistor wash is not connected normally.
THERMISTOR
The heater worked without the water in the tub.
WASH
H4
OVERHEATING
The thermistor wash is an inferior product or broke down.
ERROR
CAUSE SOLUTION
Open the water tap.
Clean the filter of the valve inlet.
Change the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Change the PCB ASS'Y.
Clean and straighten the drain hose.
Change the drain motor.
Change the valve inlet.
Change the water level sensor.
Change the PCB ASS'Y.
Close the door.
Change the switch door lock.
Change the PCB ASS'Y.
Change the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Check the leak of the tub or the hose drain.
Then change the tub or the hose drain.
Rearrange the laundry.
Change the PCB ASS'Y.
Rearrange the laundry.
Change the motor.
Change the PCB ASS'Y.
Check the connector of the motor.
Change the motor.
Change the water level sensor.
Change the thermistor wash.
Check the connector of the thermistor wash.
Check the water level.
Change the thermistor wash.
TROUBLESHOOTING GUIDE 31