Table of Contents
Advertisement
WARNING
Empty the magazine to prevent a fastener from being
ejected at the next stage of work in the event that
internal parts of the fastener driving tool are not in the
starting position following maintenance and repair work
or transportation.
WARNING
Connect the fastener driving tool to the compressed
air supply using suitable pressure hose equipped with
quick-action connectors.
WARNING
Check for proper functioning by applying the safety yoke
of the fastener driving tool to a piece of wood or wooden
material and actuating the trigger once or twice.
This tool is designed to operate on clean, dry compressed
air at regulated pressures between 4.8 - 8.3 bar (70 - 120
will do the job.
NOTE:
may damage the tool.
The tool and air hose must have a hose coupling that
allows all pressure to be removed from the tool when the
coupling is disconnected.
WARNING
Always use a coupling that discharges all the
hose coupling is disconnected. Using a coupling that
does not discharge the compressed air could cause
unintended operation and serious personal injury.
WARNING
Do not climb rigging or scaffolding while carrying a tool
that is connected to an air hose. Doing so could result
in serious personal injury.
Connect the tool to the air supply with a 1/4 in. female
quick connector. For maximum tool performance, a 3/8 in.
LOADING THE TOOL WITH FASTENERS
tool so that the safety yoke is not pointing towards the
operator or any other person or animals.
The tool's driving mechanism may cycle when the tool
tool to a pressurized air supply before loading fasteners
to prevent injury from unintended cycling. Always make
sure the tool's magazine is empty at the beginning of
each work session, before connecting to an air supply.
1. Connect the tool to the air supply.
2. Release the magazine lock and slide open the
magazine.
3. With the safety yoke of the tool pointed away from you,
feed a strip of fasteners into the magazine. Be sure the
fasteners are pointed downward.
–
To fill the tool with 18 gauge nails, place the nails
in the left channel with the nail tips pointing down.
Ensure that the nail tips rest on the bottom of the
channel and the nail heads are seated in the slot.
–
To fill the tool with 16 gauge nails, place the nails
in the right channel with the nail tips pointing down.
Ensure that the nail heads rest on the top of the
channel.
–
To fill the tool with crown staples, insert the shanks
of a strip of staples into both channels of the
magazine. Ensure that the crowns rest on the top
of the magazine.
NOTE: Ensure the 18 gauge nails and 16 gauge nails
are placed into the correct channel. Failure to do so
could cause jamming of the nails.
Keep the tool pointed away from yourself and others
when loading fasteners. Failure to do so could result in
possible serious personal injury.
4. Close the magazine.
Use only the fasteners recommended for use with this
tool. The use of any other fasteners can result in tool
malfunction, leading to serious injuries.
Never load fasteners with the safety yoke or trigger
activated. Doing so could result in possible serious
personal injury.
6
WARNING
WARNING
WARNING
WARNING
WARNING
Advertisement
Table of Contents
