Norcold N4000 Installation And Owner's Manual page 20

- Make sure the baffle is the full width of the inside of the enclosure.
The front baffle [13] completes the combustion seal at
!
the top of the refrigerator. Make sure that the baffle
WARNING
is sealed around all edges (against the top edge of
the refrigerator, against the enclosure side walls, and
against enclosure ceiling in front of the vent). See also
section entitled "Combustion Seal".
- If the design of the vehicle does not allow you to install the roof exhaust vent
directly above the condenser [11] of the refrigerator (See Art02338):
- Align the roof exhaust vent [12] above the condenser [11] of the
refrigerator and move it inboard as necessary.
- Install two baffles [13] to prevent stagnant hot air in the area [14] above
the refrigerator.
- Make sure the baffles are the full width of the inside of the
enclosure.
- Make sure that the baffles are no more than 45° from vertical [20].
- Put one baffle between the top rear edge of the refrigerator and the
inside edge of the upper exhaust vent opening.
!
WARNING
- Put the other baffle between the outside edge of the upper
exhaust vent opening and the side wall of the vehicle.
- If the depth of the enclosure is 20 3/8 inches or more and is less than
21 3/8 inches [27], no baffles are necessary at the rear of the enclosure.
Installation and Owner's Manual 20
The front baffle [13] completes the
combustion seal at the top of the refrigerator.
Make sure that the baffle is sealed around
all edges (against the top edge of the
refrigerator, against the enclosure side
walls, and against enclosure ceiling
in front of the vent). See also section
entitled "Combustion Seal".
13
14
20
11
10
27
14
13
10
27
12
19
16
19
16
17
9
Art02338
12
19
11
21
17
9
Art02341