EVGA Z270 FTW-K Initial Installation page 35

EVGA Z270 FTW – K (132-KS-E277)
Incorrect installation Example:
*NOTE* This is one of the most common examples of an incorrect installation
of a M.2 device. Do not intentionally attempt this, or complete your installation
with this example. Doing so could cause damage to the device or the M.2 port.
Using the image below, notice how the gold fingers fail to fully seat in the M.2 slot. This
often occurs if the drive was pushed into the slot from a nearly parallel starting position,
rather than an angle, causing the M.2 device to not seat fully. As a result, this may cause
a drive detection failure by the BIOS, the drive will be detected with the description in
gibberish (e.g. characters in the name, such as @, #, $, %, *, etc.) and/or notifications
that the drive has corrupt data stored on it.
Moreover, if the device's connection looks like this, then screwing down the device will
likely be a VERY tight fit, if even possible, which is another sign that the device is not
seated properly.
In conclusion, if the install device looks similar to the image below, please remove and
reseat it using the instructions above. DO NOT POWER THE SYSTEM ON IF
THE CONNECTOR RESEMBLES THIS PICTURE.
For further M.2 setup instructions please see Page 55.
- 35 -