Advertisement
9.2.9. S REEL/T REEL/IDLER ARM ASS'Y/IDLER GEAR (Refer to
1. Remove the S Reel and T Reel.
2. Remove the 2 Polyslider Washers
3. Remove the Idler Arm Ass'y and Idler Gear.
NOTE
1. Take care not to damage the gears of the S Reel and T Reel.
2. The Polyslider Washer may be remained on the back of the reel.
3. Take care not to damage the shaft.
4. Do not touch the section "A" of S Reel and T Reel. (Use gloves.)
(Refer to
Fig. 2-9-A
5. When you install the reel, clean the shaft and grease it (FG-84M).
(If you do not grease, noise may be heard in FF/REW mode.)
6. After installing the reel, adjust the height of the reel. (Refer to
MECHANICAL ADJUSTMENT)
NOTE
) Do not adhere the stains on it.
Fig. 2-9-A
16
.
Fig. 2-9-A
)
Advertisement
