Program The Tv, Vcr And Aux Key - EchoStar DVR-5000 HDD Viaccess User Manual

EchoStar Quattro, Programmable Remote Control Unit
4.

PROGRAM THE TV, VCR AND AUX KEY

You can program the mode keys (TV, VCR, AUX) with only one device per key.
I
The TV key is used to setup the RCU to control your basic TV functions;
I
The VCR key is used to setup the RCU to control your basic VCR or DVD functions;
I
The AUX key is used to setup the RCU to control your amplifier, tuner or miscellaneous
audio equipment.
You can program the SAT mode keys to control a number of satellite receivers. The RCU is
default programmed to control the EchoStar satellite receiver that came in the same box.
NOTE
Some codes are quite similar. If your device does not respond or does not function
properly with one of the codes, try another code listed under your brand.
4.1. SETUP WITH USE OF THE EQUIPMENT CODE LIST
NOTE
The procedures to set the RCU for the TV, VCR, DVD and Audio equipment is
identical, therefor only the procedure to setup the TV is given.
1. Find your brand in the equipment code list.
2. Switch your TV to on and make sure a broadcast is seen.
3. On the RCU, press the TV key continuously until the indicator stays on.
4. Release the TV key and make sure the indicator blinks continuously.
5. Use the numerical keys to enter the first code that is listed behind your brand name.
6. Monitor the TV key and note that the indicator blinks three times.
7. Aim the RCU at your TV and press the on/standby key and make sure the TV switches
off.
8. Now the RCU is programmed to control your TV.
9. If there is no response aim and press again. If there is no response, the first code is not
valid for your TV. Repeat the previous steps with the next code given.
10. If the TV does not respond at the last code, continue with the next procedure
Digital Satellite Receiver
Numerical keys
The Numerical keys (0-9, TV/RAD, FAV) activates the same functions as
available on your original remote control unit, such as direct access
program selection.
TV/RAD key
If the function is available, this key operates as the AV key for TV and as
TV/VCR for VCR.
FAV key
If your original remote control unit uses one/two number keys (usually
marked as -/--, 10 or 20), press this key as usual.
Teletext keys
If the function is available, some transport keys control the main teletext
functions. You find the teletext functions under the given keys:
teletext off; press the stop key
teletext on; press the play key
teletext mix; press the rewind key
teletext hold; press the pause key
teletext expand; press the record key
Appendix 2
A2
Page A2 - 3