Receiver description
TROUBLESHOOTING
1.
TO SOLVE A TV OR RADIO RELATED PROBLEM
Problem
1. No picture or sound in the
TV or radio mode.
2. Bad picture or noisy
sound in the TV or radio
mode.
3. The TV shows a
No Signal message.
4. There is no Dolby Digital
(AC-3) sound to my other
equipment.
5. I cannot view or listen to a
scrambled channel.
DSB-808 2Ci Conax
Possible cause
■
Receiver is in standby.
■
Cable related problems.
■
Dish/LNB related
problems.
■
Bad reception of the
signal.
■
Signal interference with
UHF-installation.
■
Bad reception of the
signal.
■
The equipment is
connected to the receiver
with a RCA or SCART
cable only.
■
The Dolby Digital option is
not set to On.
■
The CI-module/Smartcard
is not valid.
■
The CI-module/Smartcard
is not (correctly) inserted.
Troubleshooting
Section 4
What to do?
■
Switch the receiver on.
■
Check the cable
connections.
■
Make sure the dish and
LNB are correctly
adjusted.
■
Make sure the dish and
LNB are clean and
correctly adjusted.
■
Check the UHF settings.
Make sure you use the
correct channel. Please
refer to the TV/Radio user
guide.
■
Make sure the channel
selected transmits.
■
Make sure the correct
dish or LNB is selected.
■
Make sure the dish and
LNB are clean and
correctly adjusted.
■
Connect the
S/PDIF connector of the
receiver to the Dolby
Digital input of the
receiving equipment.
■
In the User preferences -
User profile menu, set the
Dolby Digital option to On.
■
Insert, for this service, a
valid CI-module/
Smartcard.
■
Insert the CI-module/
Smartcard correctly.
English
4
Page 4 - 1