Getting Started; Unpacking; Install Your Receiver - EchoStar T-222 FTA User Manual

EchoStar Terrestrial User Interface

GETTING STARTED

1. U
NPACKING
CAUTION
It is recommended to keep the packaging
materials for a period of time. In case of
warranty claims, we can request to return
the receiver in the original packaging to
protect the electronics. Failing to do so
might void the warranty.
1.1.
TO UNPACK YOUR RECEIVER
WARNING
K
EEP AWAY THE PLASTIC PACKAGING FROM
. T
CHILDREN HE PLASTIC PACKAGING MAY CLING
TO NOSE AND MOUTH AND PREVENT
.
BREATHING
When you unpack the contents of the box,
confirm that all the parts are included.
Unpack the contents of the box carefully.
Electronic equipment as satellite receivers are
easily damaged when you handle it roughly.
Examine all parts for damage that may have
occurred during shipment. If you find any
damage, stop to unpack the box and call the
shop where you bought the receiver.
To help avoid possible damage to the receiver's
electronics, allow the receiver to adapt to the
ambient temperature and humidity level. This to
avoid condensation.
1.2. T
HE CONTENTS OF THE BOX
The box contains:
■
A receiver;
■
A mains power adapter;
■
A remote control unit (RCU);
■
A pair of batteries (for the RCU);
■
A set of documentation.
www.echostar-int.com
2. I
NSTALL YOUR RECEIVER
WARNING
ALL EQUIPMENT INVOLVED IN THE INSTALLATION
TASK MUST BE INSTALLED CORRECTLY AND
. M
SWITCHED OFF AKE SURE THAT IT IS SAFE TO
PROCEED WITH THE INSTALLATION TASK
U
NSAFE CIRCUITS AND INSTALLATIONS CAN
( )
CAUSE SERIOUS INJURY OR DAMAGE TO
.
EQUIPMENT
:
2.1. P
ROGRAM THE RECEIVER
This section assumes that the antenna
installation is completed and operational and
your receiver is connected to your TV.
1. Apply the 12Vdc to the receiver.
2. Press the On/Standby key and wait for the
start-up to complete.
3. When the Guided setup screen shows,
press the green key to start the automatic
channel search.
4. Press the OK key and wait for the Search
channels to complete
5. Press the OK key to confirm.
6. Now the receiver is ready for use.
If there are no channels found, Make sure the
antenna is aimed in the correct direction.
1. When the Guided setup screen shows,
press the red key to access the signal
indicator.
2. Press the i-key for detailed help.
3. Turn the antenna and use the signal
indicator to find the best signal.
4. In the Guided setup menu, press the green
key to start the automatic channel search.
Getting Started
Q
UICK REFERENCE GUIDE
.
Press the green key.
Wait for the Search channels to complete.
Press Ok, now the receiver is ready for use.
Section 2
Page 2 - 1