Table of Contents
Advertisement
Figure 131. Removing the LOM card and rear I/O board
Next steps
1.
Replace the LOM card and rear I/O
Installing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
145
Advertisement
Table of Contents
