Table of Contents
Advertisement
II. Installation and Operating Instructions
A. Checks Before Installation
1. Install in accordance with all applicable national, state, and local regulations.
. Remove the shipping carton, tape, and packing material. If any are left in the
icemaker, it will not work properly.
3. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
1) Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
7) This icemaker needs a storage bin. The recommended storage bin is Hoshizaki Ice
Storage Bin, Model B-500 series.
8) On remote air-cooled model, a remote condenser unit is needed. The recommended
remote condenser unit is Hoshizaki Remote Condenser Unit, Model URC-9F.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and towards
you.
• Top Panel: Lift up at front slightly, push rearward,
and lift off.
• Side Panel (R): Remove the screw. Slide forward
slightly and lift off.
• Insulation Panel: Lift up slightly and pull towards you.
• Base Cover: Lift up slightly and pull towards you.
IMPORTANT
8
Fig. 1
Advertisement
Table of Contents
