Table of Contents
Advertisement
I. Startup
1. All parts are factory-adjusted. Improper adjustments may result in failure.
. If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
3. Do not operate the icemaker in the "WASH" position without water in the
water tank. This will cause damage to the water pump seal.
4. At startup, confirm that all internal and external connections are free of leaks.
1) Open the water supply line shut-off valve.
) Remove the front panel.
3) Move the control switch on the control box to the "ICE" position.
4) Replace the front panel in its correct position.
5) Turn on the power supply, and allow the icemaker to operate for a total of 10 minutes.
6) Turn off the power supply, and remove the front panel and the base cover.
7) Remove one end of the pump tubing to drain the water tank. See Fig. 10.
8) After the water tank has drained, replace the pump tubing in its correct position.
9) Clean the storage bin liner using a neutral cleaner. Rinse thoroughly after cleaning.
10) Replace the base cover and the front panel in their correct positions.
11) Turn on the power supply to start the automatic icemaking process.
1) When the icemaker is running, hold an ice cube in contact with the bulb. The icemaker
should stop within 3 to 10 seconds. Adjustment may be needed, particularly at higher
altitude locations.
CAUTION
Fig. 10
18
Advertisement
Table of Contents
