Parts Replacement Information Guide; Payne Heating & Cooling; Electrical Group; Casing Group - Payne PG95ESA Installation, Start-Up, Operating And Service And Maintenance Instructions

Casing Group

Blower door
Bottom plate
Control door
Door knob assembly
Top filler plate

Electrical Group

3- -Amp fuse
Circuit board
Control box
Door switch
Junction box
Limit switch(es)
Transformer
Blower Group
Blower housing
Blower motor
Blower wheel
Cut- -off plate
Power choke (where used)
Filter Group
Filter(s)
Media Cabinet (when used)
TO OBTAIN INFORMATION ON PARTS: Consult your installing dealer or classified section of your local telephone directory under
"Heating Equipment" or "Air Conditioning Contractors and Systems" headings for dealer listing by brand name or contact:
Have available the model number, series number, and serial number located on the unit rating plate to ensure correct replacement part.
MODEL
PG95ESA
FIRE, EXPLOSION, ELECTRICAL SHOCK AND CARBON MONOXIDE POISONING HAZARD
Failure to follow this warning could result in dangerous operation, personal injury, death or property damage.
Improper installation, adjustment, alteration, service, or maintenance can cause personal injury, property damage, or death. Consult a
qualified installer, service agency, or your local gas supplier for information or assistance. The qualified installer or service agency
must use only factory- -authorized replacement parts, kits, or accessories when modifying this product.
E2019 Payne Heating & Cooling Systems D
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.

PARTS REPLACEMENT INFORMATION GUIDE

PAYNE HEATING & COOLING
Syracuse, New York 13221- -4952
MAJOR COOLING
SERIES CAPACITY
A 30
!
7310 W. Morris St. D Indianapolis, IN 46231
Gas Control Group
Burner
Flame sensor
Gas valve
Hot surface igniter
Manifold
Orifice
Heat Exchanger Group
Containment plate
Coupling box
Heat exchanger assembly
Primary HX cell panel
Secondary HX assembly
Tubing gaskets
Inducer Group
Collector box
Condensate trap
Condensate trap elbow
Gaskets
Inducer
Inducer assembly
Inducer motor capacitor (when used)
Inducer motor module (when used)
Pressure switch(es)
Consumer Relations Department
P.O. Box 4952
1- -800- -417- -2963
Model Nomenclature
HEATING
INPUT
026
WARNING
Edition Date: 04/19
86
WIDTH MINOR SERIES
A A
Catalog No: IM---PG95ESA ---01
VARIATIONS
A
Replaces: NEW