Ryobi RVC-1430PPT-G Owner's Operating Manual

Ryobi RVC-1430PPT-G Owner's Operating Manual

Wet and dry vacuum cleaner
Hide thumbs Also See for RVC-1430PPT-G:

Advertisement

Quick Links

RVC-1430PPT-G
WET AND DRY VACUUM CLEANER
OWNER'S OPERATING MANUAL

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi RVC-1430PPT-G

  • Page 1 RVC-1430PPT-G WET AND DRY VACUUM CLEANER OWNER’S OPERATING MANUAL...
  • Page 2 DESCRIPTION Components list 1. Extension Wand (x2) 12. Blower connection 2. Floor tool 13. Filter basket 3. Crevice tool 14. Safety float valve 4. Round brush 15. Cartridge filter cap 5. Hose set 16. Cartridge filter (non washable) 6. Castor (x4) 17.
  • Page 3 DESCRIPTION Please refer to pages 2 - 4 for instructions...
  • Page 4 DESCRIPTION Please refer to pages 2 - 4 for instructions...
  • Page 5 DESCRIPTION Please refer to pages 2 - 4 for instructions...
  • Page 6 DESCRIPTION Fig. 20 Fig. 21 Fig. 22 Fig. 23 Fig. 24 Fig. 25 Please refer to pages 2 - 4 for instructions...
  • Page 7 DESCRIPTION Fig. 26 Fig. 27 Fig. 28 Please refer to pages 2 - 4 for instructions...
  • Page 8 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications...
  • Page 9: General Power Tool Safety Warnings

    Don’t vacuum up liquids that are hotter than 60°C or any GENERAL POWER TOOL SAFETY WARNINGS poisonous or flammable dusts. Never lay the appliance on its side. Pay particular WARNING! attention to a horizontal position and adequate stability This appliance complies with the compulsory safety on stairs.
  • Page 10: Disposal Information

    Only store the appliance in a safe and dry location Don’t use the appliance without a dust bag (an exception outside the reach of children. is wet vacuuming or with the cartridge filter). Make sure that the dust bag is inserted into the appliance correctly. Please also pay particular attention to the following When using the appliance, make sure that no hair, “Special Safety Rules”.
  • Page 11: Operation

    Insert the handle into the slots on the power head and Ensure that the power cord is disconnected from the pressure into place (Fig. 6). power outlet. Ensure that the tank is clean and free of dust and dirt. For dry vacuum cleaning, install the supplied cartridge Remove the cartridge filter and dust bag, and install a filter and dust bag (Fig.
  • Page 12: Maintenance

    Cleaning Foam Filter WARNING Carefully remove foam filter. (Fig. 27) Wear a dust mask if blowing creates dust that might Use a mild soap and water solution to wash foam filter be inhaled. and rinse with clean water. (Fig. 28) Insert the large end of the hose into the blower Allow filter to air dry before installing and using again.
  • Page 13: Troubleshooting

    TROUBLE SHOOTING WARNING To reduce the risk of personal injury, unplug the cleaner before performing maintenance/troubleshooting checks. Problem Cause Solution The appliance doesn’t work No power Check the power supply. Functional fault in the power cord, switch, Have the damaged part checked by or motor qualified personnel or replace it.
  • Page 16 Techtronic Industries (Australia) Pty. Ltd. 31Gilby Road, Mt. Waverley, VIC 3149, Australia Techtronic Industries New Zealand Ltd. 2 Landing Drive, Auckland Airport, Mangere, New Zealand 2022...

Table of Contents