Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Ryobi RVC-1220I-G
Summary of Contents for Ryobi RVC-1220I-G
- Page 1 RVC-1220I-G WET AND DRY VACUUM CLEANER OWNER’S OPERATING MANUAL...
- Page 2 DESCRIPTION Components list 1. Extension Wand (x3) 11. Filter basket 2. Floor tool 12. Safety float valve 3. Crevice tool 13. Cartridge filter cap 4. Hose set 14. Cartridge filter (non washable) 5. Castor (x4) 15. ON/OFF switch 6. Handle 16.
- Page 3 DESCRIPTION Please refer to pages 2 - 4 for instructions...
- Page 4 DESCRIPTION Please refer to pages 2 - 4 for instructions...
- Page 5 DESCRIPTION Please refer to pages 2 - 4 for instructions...
- Page 6 DESCRIPTION Fig. 20 Fig. 21 Fig. 22 Fig. 23 Fig. 24 Fig. 25 Please refer to pages 2 - 4 for instructions...
- Page 7 DESCRIPTION Fig. 26 Fig. 27 Please refer to pages 2 - 4 for instructions...
- Page 8 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications...
- Page 9 Don’t vacuum up liquids that are hotter than 60°C or any GENERAL POWER TOOL SAFETY WARNINGS poisonous or flammable dusts. Never lay the appliance on its side. Pay particular WARNING! attention to a horizontal position and adequate stability This appliance complies with the compulsory safety on stairs.
- Page 10 Only store the appliance in a safe and dry location Don’t use the appliance without a dust bag (an exception outside the reach of children. is wet vacuuming or with the cartridge filter). Make sure that the dust bag is inserted into the appliance correctly. Please also pay particular attention to the following When using the appliance, make sure that no hair, “Special Safety Rules”.
- Page 11 Insert the handle into the slots on the power head and Ensure that the power cord is disconnected from the pressure into place (Fig. 6). power outlet. Ensure that the tank is clean and free of dust and dirt. For dry vacuum cleaning, install the supplied cartridge Remove the cartridge filter and dust bag, and install a filter and dust bag (Fig.
- Page 12 The unit will now blow through the vacuum hose and can ENVIRONMENTAL PROTECTION be used to clear obstructions within the hose. Once you have finished operation, flip the switch to the Recycle raw materials instead of disposing of as ‘O’ (OFF) position and unplug the power cord from the waste.
- Page 13 FAQ’s WARNING To reduce the risk of personal injury, unplug the cleaner before performing maintenance/troubleshooting checks. Problem Cause Solution The appliance doesn’t work No power Check the power supply. Functional fault in the power cord, switch, Have the damaged part checked by or motor qualified personnel or replace it.
- Page 16 Techtronic Industries (Australia) Pty. Ltd. 31Gilby Road, Mt. Waverley, VIC 3149, Australia Techtronic Industries New Zealand Ltd. 2 Landing Drive, Auckland Airport, Mangere, New Zealand 2022...