Table of Contents
Advertisement
Precautions for installation
Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
Installation place
<WV-S1531LNS (Heavy salt damage resis-
tance)>
The camera has heavy salt damage resistance
treatment applied, but this does not ensure
complete resistance against corrosion.
Please pay attention to the installation location
such as in places where seawater does not
splash directly.
Especially when installing this product in coast-
al areas and area that are sprayed with snow-
melting agent that are not exposed to rainwa-
ter, periodically clean by rinsing to remove
adhered salt.
Periodically inspect the camera when installing
it in coastal areas or areas that are sprayed
with snow-melting agent.(Replace parts as
necessary.)
Prepare the foundation of the installation site,
installation support, and any other installation
setting with heavy salt damage resistance
treatment.
<WV-S1531LTN / WV-S1531LN / WV-S1511LN>
The product can not be installed in areas by
the sea, the seashore, or where snow-melting
agent is sprayed.
Power supply
This product has no power switch.
When performing electrical work, make sure the
camera can be turned on and off. When an
Ethernet cable or power cable is connected, the
power is turned on. When cleaning the product,
remove the Ethernet cable or disconnect the
power cable from the main power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations subject to corrosive gases such
as from hot springs, volcanic regions, etc.
• Locations where the temperature is not
within the specified range (
• Locations subject to vibrations, such as on
vehicles, marine vessels, or above product
lines (This product is not designed for on-
vehicle use.)
• Locations subject to condensation as the
result of severe changes in temperature (In
case of installing the product in such loca-
tions, the front cover may become foggy
or condensation may be caused on the
cover.)
13
☞
page 27)
Advertisement
Table of Contents
