Table of Contents
Advertisement
Removal of Fan Rotor / Fan Motor
Step
2. Detach the fan motor.
Remove the 2 screws
1
on the left side and
remove the fan harness
cover.
(1) Disconnect the relay
2
harness.
(2) Pinch the both sides
of the spring.
(3) Pull out the
connector from the
plate.
3
Remove the 2 screws
on the right side and
remove the fan motor
stand.
The left 2 screws, which
tighten the fan harness
cover, have been
already removed at
procedure 1.
12
Procedure
Fan
harness
cover
Screws
(3)
(2)
(2)
(1)
Fan motor stand
Points
<Attention in the fan motor
installation>
Before you tighten screws, be
sure that the rubber vibration
isolators (front, back) of the fan
motor firmly fit into the both
holes of the installation board
and fan motor cover when you
install a fan motor.
(R18535)
Screws
(R18536)
Removal Procedure
Si06-760
(R4647)
Advertisement
Table of Contents
