Table of Contents
Advertisement
Alarm Card Setup
If you require assistance to connect an Alarm Card, please refer to page 8.
Set switches on SW1
A
to the correct address
(see full guide on page 31)
Connect the Alarm Card (see full guide on page 8)
B
The FBM should detect
C
the Alarm Card
'System status' diagram to the right)
Ensure the number of
D
alarms on the 'Status' page
corresponds to the number of Alarm Cards
E.g. Each Alarm Card supports 16 alarms, so if you have one Alarm Card connected you should have 16 alarms
active and if you two Alarm Cards connected you should have 32 alarms active, and so on.
Go to Alarm Status, where the enabled alarms
E
should be displayed and enabled
As shown in the screenshot below: Alarm 1 is set and enabled. When triggered, Camera 1 on Monitor 1 will go to
Preset 2, Keyboard 1 alarm key will beep until disabled and Relay 2 will close (on Alarm Card 1).
Action Enabled
Camera Number
Save & Restart.
F
(as shown in the
Alarm Number 1
Preset Number
1
2
Monitor Number
Keyboard Number
1
Trigger Relay
1
2
39
Advertisement
Table of Contents
