Initial System Start-Up; Adjusting Volume; Lowering Volume Quickly; Setting Time - Alpine CDA 9883 Owner's Manual

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press (OPEN) to open the front panel, and then
remove it.
3
Press RESET with a ballpoint pen or similar pointed
object.
RESET switch

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press /RTN to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing /RTN again will bring the audio back to its
previous level.

Setting Time

1
Press and hold FUNC./SETUP for at least 2 seconds
to activate the SETUP selection mode.
2
Turn the Rotary encoder to select CLOCK ADJUST,
and then press / /ENT.
3
Turn the Rotary encoder to set hour.
4
Press / /ENT.
5
Repeat steps 3 and 4 above to set hour and minute.
6
Press and hold FUNC./SETUP for at least 2 seconds
to return to normal mode.
• Pressing /RTN returns to the previous SETUP mode.
• If no operation is performed for 60 seconds, SETUP is canceled.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
after setting the "hour." Minutes will reset to 00. If the display shows
over "30" minutes when you do this, the time will advance one hour.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Connectable to Remote Control Interface Box
This unit may be controlled from the vehicle's audio controls.
An optional Alpine Remote Control Interface Box must be
used. For details, contact your Alpine dealer.
/ /ENT for at least 2 seconds
Remote control sensor
7
-EN