Grizzly G0967X Owner's Manual page 38

6.
Place the 91 / " fence tube over the 91
3
8
front rail, secure with (9) M8-1.25 x 12 flange
bolts, as shown in Figure 37, then install the
handwheel handles.
Handwheel
Handles
Figure 37. Fence tube mounted to front fence
rail.
On/Off Switch and Blade
1. Fasten the switch to the left end of the front
rail with (2) M8-1.25 x 12 flange bolts, then
insert the switch disabling lock, as shown in
Figure 38.
Stop Paddle
Figure 38. Switch installed.
-26-
2.
/ "
1
4
x9
3.
4.
Switch
Disabling
Lock
5.
Turn the lock knob that secures the table
insert so it is parallel to the inner slot, as
shown in Figure 39, then remove the insert
and set it aside.
Lock Knob
Figure 39. Insert lock knob unlocked.
Raise the arbor all the way up and set the
arbor angle to 0°.
Unthread the lock knob on the riving knife/
blade guard mounting block (Figure 40) sev-
eral turns. Push the riving knife away from the
knob, then lift the riving knife up to remove it.
Riving Knife
Mounting Block
Figure 40. Riving knife installed.
Note: The riving knife is installed for shipping
purposes. Two pins in the mounting block
insert into matching slots on the riving knife,
keeping it secured.
Install the saw blade as outlined in Blade
Installation on Page 34.
G0605X1-6X1, G0696X-97X (Mfd. 8/11)
Lock
Knob