Table of Contents
Advertisement
3. Select the desired Security Type.
4. Select the Authentication Type for WEP.
5. Select WEP Key Index and Key, then click
Finish. Make sure to copy down the
encryption key.
6. Wait 35 seconds while the Access Point
reboots.
7. Click Status->Remote AP, the Connection
Information should be display.
8. Set Wireless client associate to ESSID
"Repeater_Main_AP" with corrent WEP key.
9. Click Status->Client, the Repeater AP
Clients should be display.
Note :
1. The Channel of Repeat AP should be the same with Main Base Station.
2. To verify wireless clients can associate ESSID "Repeater_Main_AP" with WEP key.
3. To verify wireless clients can use ping command to "192.168.2.254".
4. If you can not access Main Base Station, verify the IP address of the wireless client (PC or Laptop) is in the same subnet
with Main Base Station.
12
Advertisement
Table of Contents
