Table of Contents
Advertisement
Setting Up the Client Bridge (Client Station)
1. Follows steps 1-6 (Select "Client Bridge"
mode on step 4) in Section 3 Configuring
the Access Point. Make sure you change
the IP address of the Client Station to be
different.
2. Configure the DHCP Server settings to
match your demandand then click Next
button.
3. Click Site Survey button. The system
will automatically scan and display the scan
results of all AP existing near by the system
4. Use Main_AP as an example here where the
AP is encrypted via WPA2-PSK/ AES security
type. Click Select button of the Main_AP, and then
click Next button.
9
Advertisement
Table of Contents
