Installing The Panels; General Warnings; Finishing Touches - Jacuzzi Sharp Installation Manual

INSTALLING THE PANELS

(where present)
I Secure the metal elastic support/s (L) by means of the two self-
tapping screws to the small block (N) under the tub rim (
I Click the springs (P) onto the legs located at the corners of the tub
and make them slide up until they touch the top, pushing them from
both sides so that they settle inside the tub rim (
ring (R) into the groove of the leg.
I Insert the plastic supports (S) into the legs (Q) (
While maintaining the height of the tub from the floor (57 cm,
i
2) adjust the height of the plastic support (S) by means of the ring
nut (Y) according to the height indicated (
To lock the plastic support (S), tighten the screw nut (X) by means
of a spanner , applying light force.
I If side panels are to be installed, secure the plastic clips (T) on the
panel itself by means of the self-tapping screws (
Use holes "1-2" to assemble the left panel and holes "3-4" for the right
panel.
I Insert the side panel between the springs (P) and the tub rim
i
( 12). Lift it up until the clips (T) are aligned with the plastic
supports (S) and click it onto the supports themselves.
To adjust to a perfect right angle of the panels, use the screws (V).
i
I (
12) On the screws (U) apply the provided white caps.
WOOD PANEL ASSEMBLY
(where present)
I Follow the relevant assembly instructions.

FINISHING TOUCHES

i
I (
13 ) Take the bottle containing the liquid sanitiser and pour
it in the relevant hole (1). Close and insert the plug (2) (refer to
the "use and maintenance manual").
i
I (
14 ) Remove the protective film from the lower part of the
headrest (1). Position the headrest on the backrest (2).
Carefully apply silicone to all the rim, in the points that rest against
the wall (3). It is advisable to install Jacuzzi® finishing parts, avail-
able on request (4).

GENERAL WARNINGS

JACUZZI EUROPE S.p.A. declines all responsibility in the following
cases:
i
8).
If installation is carried out by unqualified personnel and/or personnel
unauthorized to carry out installation.
i
If the norms and legal provisions, regarding the electric systems of
9). Insert the
buildings, in force in the country in which installation is carried out are
not complied with.
i
10).
If the instructions for installation and maintenance contained in this
manual are not followed.
i
If unsuitable and/or uncertified materials are used for installation.
10).
If incorrect operations are carried out that reduce the level of protection
against water jets or change the protection against electric shocks by
direct or indirect contact, or generate conditions of abnormal insula-
i
11). tion, current dispersion or overheating.
If any components or parts of the appliance are altered in relation to the
original state when supplied, releasing the Manufacturer from any li-
ability.
If the appliance is repaired by unauthorised personnel or if spare parts
are used other than the original ones supplied by Jacuzzi Europe S.p.A.
6