Advertisement
Available languages
Available languages
5. To pause dispensing before the selected volume has been
dispensed, touch Dispense Water a second time or touch the
water dispenser paddle. Touch Dispense Water or paddle
again to resume dispensing remaining amount.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the display will turn off after 1 minute. If you
have not resumed by then, it will reset back to the original
amount.
6. To select a new volume or start dispensing the same volume
again, you must first finish dispensing the selected volume or
turn off the Measured Fill feature (either by waiting 1 minute so
it will automatically turn off or by touching Cubed Ice or
Crushed Ice to manually turn it off), and then select Measured
Fill again.
TO DISPENSE WATER (FAVORITE FILL)
Favorite Fill allows you to dispense a preferred amount of water
with the touch of a few buttons.
NOTE: Water will not be dispensed using the Favorite Fill feature
unless your preferred Favorite Fill amount is saved first.
Household water pressure may affect the accuracy of the Favorite
Fill feature. So, for optimum performance of your water dispenser,
you must first calibrate Measured Fill. (See Measured Fill section).
IMPORTANT: Flush the water system before Favorite Fill. For best
results, calibration should be performed when water is not being
used in the house.
1. Place a preferred-size cup on the dispenser tray centered in
front of the ice/water dispenser paddle.
2. Select either Favorite 1 or Favorite 2, and then touch and hold
the Favorite Fill button for 3 seconds to enter into Saving mode.
The Favorite Fill icon will illuminate and remain lit while the
Favorite Fill feature is being saved.
NOTE: You may touch Favorite Fill to exit at any time in Saving
mode and the display will return to the Home screen.
3. Press and hold the water dispenser paddle, as needed, to
dispense water to the preferred-size cup.
NOTE: If overfilling or spilling occurs, discard the water and
restart the saving process.
4. When the preferred amount of water has been correctly
dispensed into the cup, touch the Favorite Fill button to confirm
the favorite amount.
When Favorite Fill amount has been confirmed, the display will
return to the home screen.
1. Put a sturdy glass under waterspout. Touch Favorite Fill to
activate.
NOTE: The amount of water you select will be dispensed.
Make sure the container can hold the entire volume. If ice is in
the container, you may need to adjust your selection.
2. Touch Favorite Fill to turn on, then touch to select Favorite 1 or
Favorite 2. Touch the third time to exit Favorite Fill display.
3. Touch Dispense Water (center button) or press paddle and the
selected amount of water will be dispensed.
� The Favorite Fill dispenser will automatically time out after 1
minute of inactivity.
� You can refill several glasses with the same measurement
by continuing to touch Dispense Water (center button) after
each glass fill.
4. Dispense water. While dispensing water, the flow of water will
automatically stop once the desired volume has been
dispensed.
� Press a sturdy glass against the dispenser paddle below
the waterspout.
or
� Place the glass below the waterspout and touch Dispense
Water for hands-free dispensing.
5. To pause dispensing before the selected volume has been
dispensed, touch Dispense Water a second time or touch the
water dispenser paddle. Touch Dispense Water or paddle
again to resume dispensing remaining amount.
6. To select a new volume or start dispensing the same volume
again, you must first finish dispensing the selected volume or
turn off the Favorite Fill feature (either by waiting 1 minute so it
will automatically turn off or by touching Cubed Ice or Crushed
Ice to manually turn it off), and then select Favorite Fill again.
TO DISPENSE ICE
WARNING
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
IMPORTANT:
� If the ice cubes are hollow or have an irregular shape, it could
be because of low water pressure. See "Water Supply
Requirements" section in the Owner's Manual.
� Ice travels from the ice storage bin through the dispenser chute
to the dispenser. To turn off the ice maker, see "Ice Maker and
Storage Bin" section in the Owner's Manual.
� The dispenser may continue to make noise and ice may
continue to dispense for several seconds after releasing the
dispenser button or paddle.
� For crushed ice, cubes are crushed before being dispensed.
This may cause a slight delay when dispensing crushed ice.
Noise from the ice crusher is normal and pieces of ice may vary
in size.
� When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
Paddle Dispensing:
1. Select the desired type of ice by pressing Cubed Ice or
Crushed Ice.
2. Press a sturdy glass against the dispenser paddle. Hold the
glass close to the dispenser opening, so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to the
paddle to activate the ice dispenser. Pressing hard will not
make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the dispenser paddle. The dispenser
may continue to make noise for a few seconds after
dispensing.
Cut Hazard
4
Advertisement
