Table of Contents
Advertisement
10.13 Fingerprint settings
In the system setting menu interface, press the up and down
buttons to switch to the "Fingerprint Settings" menu, as
shown below; then press the confirm button to enter the
fingerprint selection list, "Fingerprint Switch" and "Fingerprint
Re-recording" interface, press the up and down buttons to
select , after selecting, press the confirm button to confirm;
1. Select "Fingerprint Switch"---Open, you will enter the
fingerprint interface, as shown in Figure 4, put the finger
that needs to be recorded into the fingerprint module,
place it — move away—place, cycle operation until
prompted If the entry is successful, as shown in Figure 5,
after the fingerprint is recorded, each time you turn on
the phone, you will be prompted to enter the fingerprint
to unlock it. Even the computer and charging need to be
unlocked. Select "Off" to turn off the fingerprint, and you
don't need to enter your fingerprint to unlock it when you
turn it on and charging.
Figure 4
2. Select "Fingerprint Re-recording" to enter the re-recording
fingerprint interface. The recording method is the same as
the above.
Notice
• If the device, does not record a fingerprint, selecting
fingerprint re-recording will prompt no fingerprint.
10.14 Factory reset
With this function, you can restore to the original factory
settings. The reference picture is shown below:
Figure 5
EN
61
Advertisement
Chapters
Table of Contents
