Hamilton Beach FlexBrew 49903 Instructions Manual page 5

Single-serve coffee maker
Table of Contents

Advertisement

Available languages

Available languages

How to Brew a Single-Serve Pack
w WARNING
Burn Hazard.
If overflow occurs, unplug and allow coffee maker to cool.
To avoid hot coffee overflowing:
• Fill reservoir with cup or travel mug of water into which the coffee
will be brewed.
• Fully insert cup or travel mug on cup rest.
• Do not lift lid during the brewing process.
• If brew process is stopped early, the water must be drained from
the unit. Place a large mug on cup rest. Press ON button. Failure to
drain the unit can cause the next cup brewed to overflow.
w CAUTION
Cut Hazard.
Removable single-serve pack holder has a sharp needle. Piercing
needle on underside of lid also is sharp. Use caution when handling.
NOTES:
• Use only cold water in Reservoir. Do not use hot water.
• Do not reheat coffee in machine.
• Do not use creamer or nondairy creamer in Reservoir.
• After brewing hot cocoa single-serve packs, brew a water-only
cycle without a single-serve pack to avoid possibility of clogging
piercing needle.
• Coffee Maker brews all water in Water Reservoir while brewing.
• Press OFF Button again to STOP brewing midcycle. Remaining
water must be removed. See warning statement above.
• If ON Button flashes three times, Lid is not closed. Lower Lid until it
clicks into place. Press ON Button.
• Do not brew coffee without Removable Needle Holder locked into
place.
1. Plug into outlet.
2. Lift Lid Latch until Lid clicks into place.
3. Place Gray Removable Single-Serve Pack
Holder with Handle into Funnel.
4. Place a pack into Single-Serve Pack
Holder. Do not remove foil.
5. Close Lid and snap in place to pierce
single-serve pack.
6. Lift Water Reservoir Lid.
7. Fill cup or travel mug into which coffee
will be brewed and add water to Water
Reservoir. 10 oz. (296 ml) of water is
maximum recommended amount for
best flavor with single-serve packs.
8. Close Lid.
9. Use Cup Rest for a cup or mug, and
remove Cup Rest for a travel mug.
10. Press ON Button to start brewing.
HEATING or
LED will light up to
show that Coffee Maker is heating water.
Coffee Maker will shut off automatically
when brewing is complete.
11. Unplug.
12. Single-Serve Pack Holder should be
rinsed after every use.
3
4
7
9
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents