Advertisement
DV-505, DVL-909, DV-S9
1.2.5 Disc Determination
Determination is achieved by checking the sine wave by sweeping
the lens with the OE IC gain at L and the FSC error amplifier (SGC)
at the default setting. If no sine wave is detected, checking is retried
after switching the OE IC gain to H and increasing the gain of the
FSC error amplifier (SGC). If no sine wave is detected again, it is
regarded as the NO DISC condition.
If one half of the sine wave detected at the first lens sweep is of a
value less than 0.5 V, the OE IC gain is set to H and the peak-to-
peak value of the sine wave is roughly adjusted to 1.8 Vp-p.
By sweeping the lens around the height where the sine wave has
been detected, disc determination is performed, and the sine wave
is finely adjusted to 1.8 Vp-p.
8
Offset compensation
Lens sweep
Yes
Checking
the sine wave
None
OEIC gain = H
FCS AMP gain up
Lens sweep
Checking
Yes
the sine wave
None
NO DISC
Finely adjust to 1.8Vp-p
Less than 0.5V
Level check
More than 0.5V
OEIC gain = H
Roughly adjust to
1.8Vp-p sine wave
Disc determination
sine wave
END
Advertisement
