Table of Contents
Advertisement
Important:
• Joint both sides of the front and rear sunshields
before fitting in the main sunshield.
• Do not trap the safety wire inside.
• The safety wire is designed to support only the
weight of the camera when the camera falls.
Do not put an excessive weight that the safety
wire cannot support.
STEP 9
Fit the front and rear sunshields in the main sunshield.
• Align " " of the rear sunshield to "
main sunshield. Then, turn the front and rear
sunshields toward "LOCK" until a click is heard.
Front and rear sunshields (accessory)
Align "
STEP 10
Fix the front and rear sunshields on the camera using
the front/rear sunshield fixing screw (accessory).
(Recommended tightening torque: 0.72 N·m)
Front and rear sunshields fixing screw (accessory)
Important:
• When the power of the camera is turned on,
the camera will start panning and the position
will automatically be initialized.
Note:
• When removing the front and rear sunshields,
perform steps 8 to 10 in the reverse order.
START" of the
Main sunshield
" to "
".
STEP 11
After the installation is completed, remove the tape
wrapped around the camera while holding the
Protection Cover, and then take off the Protection
Cover.
tape
Camera
Dome cover
Protection Cover
19
Advertisement
Table of Contents
