Table of Contents
Advertisement
51
Installing an expansion card
Your server has a preinstalled riser card designed specifically for use in
the 2U rackmount chassis. Depending on the type of riser card
installed, you can install the following expansion cards:
•
Left-side riser for 2U server (default in barebone)
•
8-port 3Gb/s SAS RAID
•
Flex I/O Adapter
•
Full height 1 x PCI-E x16 connector (w/ Gen2 x8 link)
•
2 x Full height 2 PCI-E x8 connector (w/ Gen2 x4 link)
•
Right-side riser for 2U server (length under 5.6 inches)
•
Low profile 3 PCI-E x8 connectors (w/ Gen2 x4 link)
Installing a SAS card
1
Observe the pre-installation instructions on page 24.
2
Unclip the restraining latch and open in the direction shown
below (1).
3
Remove the slot shield (2).
Advertisement
Table of Contents
Troubleshooting
