Bosch TES 65539RU Instruction Manual page 52

48
Cleaning the milk system
Takes about 1 minute.
● Touch A to open the menu.
● Use I to choose Cleaning and care
and touch B to confirm your choice.
● Use I to choose Rinse the milk
system and touch B to confirm your
choice.
● Touch C to begin running the
programme.
The display 3 will indicate the progress of
the programme:
● Place an empty glass under the beverage
outlet 4 and stand the end of the suction
pipe 4d in it.
● Touch C. The milk system will
now clean itself automatically.
● Then empty the glass and clean the
suction pipe 4d.
You should also regularly clean the milk
system manually (dishwasher or by hand).
Descaling
Takes about 30 minutes.
The line at the bottom of the display
indicates the progress of the descaling
process.
F
If there is a water filter in the water
tank 5, be sure to remove it before
starting the service programme.
● Touch A to open the menu.
● Use I to choose Cleaning and care
and touch B to confirm your choice.
● Use I to choose Descale and touch
B to confirm your choice.
● Touch C to begin running the
programme.
Robert Bosch Hausgeräte GmbH
The display 3 will indicate the progress of
the programme:
● Empty and re-insert the drip tray 17.
● Place a container with a capacity of 0.5 litre
under the beverage outlet 4.
● Place the end of the suction pipe 4d in
the container.
● Touch C.
F
The following request appears:
Remove water filter if inserted ¢start.
● Remove the filter and then touch
C again.
● Pour lukewarm water into the empty
water tank 5 up to the "0.5 l" mark and
then dissolve one Bosch descaling tablet
TCZ8002 in it. For the TCZ6002 you
should always dissolve two tablets.
● Touch C.
The descaling programme will now run for
about 20 minutes.
F
If there is not enough descaling solu-
tion in the water tank 5, you will see
the prompt Refill descaler ¢start.
● Add more descaling solution and then
touch C again.
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
● Touch C.
The descaling programme will now run for
about 1 minute and rinse the appliance.
● Empty and re-insert the drip tray 17.
F
Important: Wipe over the appliance
with a soft damp cloth to ensure that
you immediately remove any traces
of descaling solution. It is possible
for corrosion to form underneath
such deposits. New sponge cloths
may contain salts that can cause rust
films to form on stainless steel, so
such cloths should always be thor-
oughly rinsed before use. Clean the
suction pipe 4d of the drinks outlet
particularly carefully.
en