Initial Use - Bosch TES 65539RU Instruction Manual

36

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines). Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting on the
appliance can be adjusted. The factory
setting for the water hardness is 4. Use
the enclosed test strip to determine the
hardness of your water supply. If this
shows a value other than 4, you will need
to programme the appliance appropriately
after it has been taken into service (see
section "Menu – Water hardness").
Setting up the appliance
● Remove any protective plastic film.
● Place the fully automatic coffee machine
on a level, waterproof surface that is able
to support its weight.
● The appliance's ventilation slits must not
be covered or obscured.
F
Important: Only use the appliance
in a frost-free room. If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before taking it into operation.
● Pull the mains plug out of the cable storage
compartment 18 and connect it to the
power supply. You can adjust the length of
the cable by pulling it further out or pushing
it back in. To do this, place the appliance
with its back flush with the edge of the
work surface and either pull the cable out
downwards or push it in upwards.
● Flip up the lid of the water tank 6.
● Remove the water tank 5, rinse it out and
fill it with fresh cold water. Do not fill it
past the "max" mark.
Robert Bosch Hausgeräte GmbH
● Replace the water tank 5, making sure
that it is straight, and push it right down
into place.
● Reclose the lid of the water tank 6.
● Fill the bean container 9 with coffee beans.
● Use the main switch J 1 to switch on the
appliance.
The control panel and the display will
be activated. The display will show the
previously specified language, which will
also be used for all subsequent display
texts. A number of different languages are
available.
● Touch I repeatedly until the display
indicates the desired language.
Deutsch
English
Français
● Touch B to confirm your selection.
The chosen language is now stored.
The brand logo will light up on the display 3.
The appliance will heat up and rinse itself,
a small amount of water will run out of the
drink outlet 4.
The appliance is ready for use when the
symbols and the display on the control
panel are lit.
en