en
Dispensing hot water
Before hot water is dispensed the milk
system should be cleaned and the milk
tube removed (see the section "Cleaning
the milk system"). If the milk system is not
cleaned small amounts of milk may be
dispensed together with the hot water.
B
Risk of burns!
The milk system 4b becomes
extremely hot. After use, always let
them cool down before you touch
them.
The appliance must be ready for use.
● Place a prewarmed cup underneath the
beverage outlet 4.
● Touch the symbol for Hot water.
● Touch C to begin dispensing the
beverage.
F
If you see the message Please
remove suction hose, proceed as
follows:
● Take off the milk tube 4c and then touch
C again.
Hot water will flow out of the outlet 4.
Adjusting the
grind setting
You can use the rotary selector 11 to adjust
the grind setting from coarse to fine.
F
Caution!
Adjust the grind setting only while the
grinding unit is running, otherwise
you may damage the appliance.
A
Risk of injury!
Do not reach into the grinding unit.
● With the grinding unit running, adjust the
selector 11 from fine (a: turn anticlock-
wise) to coarse (b: turn clockwise).
a
F
The new setting will not become
apparent until after the second cup
of coffee.
F
If the display shows the message
Select a coarser degree of grinding
resp. use a coarser ground coffee
this means that the beans are being
ground too finely. Adjust the grinding
unit to a coarser setting.
F
For dark roast coffee beans, choose
a finer grind, for lighter beans a
coarser grind.
41
b
TES65... | 02/2014