Table of Contents
Advertisement
Jumper and Connector Information
Clearing the CMOS
If you are not able to access the BIOS setup screens, the CMOS Clear jumper will need to be used to reset
the configuration RAM. The CMOS Clear jumper is located on jumper block J17.
1.
Power down the system and disconnect the AC power.
2.
Open the server.
3.
Move the jumper from pins 1 and 2 to the Clear CMOS position, covering pins 2 and 3.
4.
Reconnect the AC power, power up the system.
5.
When the system begins beeping, power it down and disconnect the AC power.
6.
Return the CMOS Clear jumper to the original location, covering pins 1 and 2.
7.
Close the server chassis, reconnect the AC power and power up the system.
Chapter 5
Chapter 5
86
Advertisement
Table of Contents
