Permissible Accessories; Storage And Handling Of The Recommended Accessory Tools; Working Procedures - Parkside PWS 125 F5 Translation Of The Original Instructions

Permissible accessories

Cutting disc
Roughing disc
Storage and handling of the
recommended accessory tools
■ Grinding tools must be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical dam-
age or environmental influences (e.g. damp).

Working procedures

NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
PWS 125 F5
125 3 M14
125 6 M14
Two-hole assembly
6500 80
Two-hole assembly
6500 80
Rough grinding
Never use cutting discs for rough
grinding!
■ Move the angle grinder with moderate pres-
sure back and forth over the workpiece.
■ For soft material, move the roughing disc
at a flat angle over the workpiece; for hard
material at a slightly steeper angle.
Abrasive cutting
Never use roughing discs for cut-
ting!
■ Use only tested fibre-reinforced cutting or
grinding discs that are approved for a periph-
eral speed of not less than 80 m/s.
Yes
spanner
Yes
spanner
GB │ MT │
57 ■