Husqvarna P 520D Operator's Manual page 121

9. Remove the locking pin on the cutting height
adjustment lever in the top left corner of the cutting
deck.
10. Push the cutting height adjustment lever down and
pull the lever horizontally.
11. Put the lever in the hole with the same number as on
the adjustment plate.
Note: Make sure the same number is selected on all
3 adjustment points.
12. Attach the locking pin on the cutting height
adjustment lever.
13. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
129 .
Number Cutting height, mm / in.
1 30 / 1.2
2 40 / 1.6
3 52 / 2
4 64 / 2.5
5 76 / 2.3
6 93 / 3.7
7 112 / 4.4
To adjust the cutting height - Combi
132 X and Combi 155 X
1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lift lever for hydraulic lift forward to lower
the cutting deck to mow position.
740 - 002 -
4. Move the cutting height lever forward and rearward
to adjust the cutting height.
Note: The selected cutting height is shown with the
numbers 1-7 on the cutting deck. Refer to the table
below
5. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
129 .
Number
To
1
2
3
4
5
6
7
To operate the air condition in the
cabin
The air condition is used to adjust the temperature in the
cabin. The air condition can also be used to remove
frost the window during the cold season.
• Engage and disengage the air condition with the
turning knob on the hose to the right of the forward
pedal.
ON
OFF
Cutting height, mm / in.
30 / 1.2
40 / 1.6
52 / 2
64 / 2.5
76 / 2.3
93 / 3.7
112 / 4.4
To
121