Husqvarna P 520D Operator's Manual page 116

13. Remove the screw and the washer at the front of the
door (C).
B
14. Fold the seat forward.
15. Put the lifting strap through the door and the
emergency exit.
16. Put the lifting strap 2 turns through the cabin.
17. Attach the lifting strap in the lifting loops of the cabin.
18. Carefully lift the cabin in the lifting strap with a lift.
19. Lift the cabin 10 cm above the product.
CAUTION: Make sure the cabin is lifted
above the bolts.
20. Carefully move the cabin forward.
21. Put the cabin in the cabin support. Refer to
of the cabin on page 141
Attach the cabin in the opposite sequence.
To attach and remove the door
1. Open the door 90 degrees.
116
A
C
Storage
2. Pull back the gas spring and loosen the ball joint.
3. Lift off the door.
Attach the door in the opposite sequence.
To attach and remove the emergency door
1. Open the snap lock handle on the emergency door.
2. Close the emergency door without locking the snap
lock handle.
3. Remove the hinge pin.
4. Open the door 90 degrees.
5. Lift off the emergency door.
Attach the emergency door in the opposite sequence.
To engage and disengage the Roll
Over Protection Structure (ROPS)
• Remove the 2 pins that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING: Obey the following
instructions for the ROPS and the safety
belt.
• Do not use the safety belt if the ROPS is
disengaged.
740 - 002 -