Husqvarna P 520D Operator's Manual page 120

3. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pushed down.
Use pedal (A) to move forward, and pedal (B) to
reverse.
A
4. Release the pedal to brake. To brake harder, press
down the other speed pedal.
Note: For P 525D, lock the speed with the speed
control catch. Refer to
525D with cabin on page 106 .
5. Pull the PTO button out to engage the drive on the
cutting deck blades.
To operate the speed control catch
The speed control catch can be set by foot to maximum
speed or low speed. Use maximum speed when the
cutting deck is in the transport position. Use the low
speed when the cutting deck is in the mow position.
• For low speed, push the speed control catch to the
middle position (A).
• For maximum speed, push the speed control catch
fully forward (B).
• To disengage the speed control catch, push the the
speed control catch fully rearward.
To operate the auxiliary lift system
The auxiliary lift system decrease the ground pressure
from the pivot wheel on the cutting deck.
120
B
Speed catch - P 525D and P
• To decrease the ground pressure, put the gas spring
in 1 of the top holes on the locking plate.
• To increase the ground pressure, put the gas spring
in 1 of the bottom holes on the locking plate.
Note: Put the gas pin in the top hole when you cut
grass.
To adjust the cutting height - Combi
132 and Combi 155
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the lift lever for the cutting deck in the transport
position.
4. Stop the engine.
5. Remove the cutting height adjustment knob on the
side of the cutting deck.
6. Put the cutting height adjustment knob in 1 of the
holes on the adjustment plate.
A B
Note: The cutting height is shown with the numbers
1-7. Refer to the table below.
7. Tighten the cutting height adjustment knob.
8. Do steps 5-7 on the other side of the cutting deck.
740 - 002 -