Table of Contents
Advertisement
Screen display
Camera image screen
[Exceeds capacity. Please reselect.]
[Check the destination media.]
[LOAD NG]
[SAVE NG]
[DISCONNECT USB CABLE.]
[CARD LOCKED.]
[CANNOT SELECT MORE CLIPS.]
[SELECT THE CLIP TO BE
DELETED.]
[SELECT THE CLIPS TO COPY.]
[SELECT THE CLIP TO RE‑
CONNECT.]
[NO CARD.]
[REINSERT OR CHECK CARD
<SLOT 1>]/[REINSERT OR CHECK
CARD <SLOT 2>]
[CANNOT COPY.]
[CANNOT RECORD.]
[REC PAUSE INVALID]
[WRITE PROTECTED]
Chapter 10 Notes — Warning system
Description
The remaining recording capacity of the memory card for
the copy destination is insufficient.
An error has occurred on the memory card for the copy
destination while copying.
Loading of the scene file has failed.
Writing of the scene file has failed.
Due to an OS non-compatible error, five minutes has
elapsed until the service mode connection is established.
The camera tried to protect or delete a clip on a memory
card that has been locked.
The camera tried to copy a clip to the memory card that
has been locked.
It has tried to select more than 99 clips.
It has tried to delete a clip without choosing any.
It has tried to copy a clip without choosing any.
It has tried to re-connect without choosing any clip.
Copying was tried to be executed without inserting a
memory card into the card slot.
It has tried to copy to an error card.
Copying was attempted while the system frequency
(59.94 Hz and 50.00 Hz) of the memory card to copy from
and the memory card to copy to are different for content
recorded in AVCHD format.
Cannot be recorded.
The camera tried to stop the next recording before the
previous recording finished writing to the memory card.
The memory card has been write-protected.
A message is displayed.
f Select the clip to copy again, or secure enough space in
the remaining recording capacity on the memory card for
the copy destination.
A message is displayed.
f Confirm the memory card for the copy destination.
A message is displayed.
f Check the memory card.
A message is displayed.
f Check the memory card.
A message is displayed.
f Confirm if the OS in use is supported by the camera.
A message is displayed.
f Unlock the memory card.
A message is displayed.
f Execute the process such as copying by every 99 clips.
A message is displayed.
f Select a clip to be deleted.
A message is displayed.
f Select a clip to be copied.
A message is displayed.
f Select the clip to be re-connected.
A message is displayed.
f Insert a memory card into the card slot.
A message is displayed.
f Check the memory card.
A message is displayed.
f Set the same system frequency (59.94 Hz system or
50.00 Hz system) for the content of the memory card to
copy from and the memory card to copy to.
f The system frequency information for the AVCHD format
is confirmed at the time of formatting or at the first
recording.
A message is displayed.
f Perform recording after making it possible.
A message is displayed.
f Stop recording after writing to the memory card is
complete. Recording can be stopped after the message
that is displayed disappears.
A message is displayed.
f Insert a memory card with write access.
– 203 –
Behavior and cause
Advertisement
Table of Contents
