Bardiani Valvole GIOTTO TOP Instruction, Use And Maintenance Manual page 23

9 Disposal
9 Disposal
At the end of its service life, the device must be recycled in accordance with the legislation in force in the
country of valve use.
Any hazardous residues must be taken into consideration and adequately handled.
The control unit is made up of: elastomers (gaskets), plastic (control unit) and electrical components
(terminal board, solenoid valves, sensors).
Adhere to the following steps before disconnecting the control unit and refer to the heading "General
Maintenance".
- Make sure that the line on which the control unit is installed is not in operation
Disconnect the air supply
-
- Disconnect the electrical supply
Remove the control unit from the valve
-
To dismantle the control unit, refer to the heading "Disassembly"
-
EN-IST-GIOT360-1021
23