Cancelling Devices (Main Monitor/Extension Monitor) - Panasonic VL-MWD275 Operating Instructions Manual

9. Expanding the system
When repeaters are used:
Using 2 repeaters connected together ("Connect
together" setting page 26)
This extends the signal away from the main monitor by
sending signals directly between repeaters. This is
useful when you want to connect to sub monitors over
long distances.
When repeaters are not used:
When repeaters are used:
9.2.1 Registering repeaters
1
Main monitor:
N ® select "Register/Cancel" ®
M
2
Select "Register" ®
R If you are prompted to register your main monitor,
select "Main monitor" ®
3
Select "Repeater" ®
4
Select the number of the repeater to be registered
®
.
R When registering a repeater for the first time:
Go to step 5.
30
.
.
.
.
When registering a repeater for the second
time:
Select the connection method according to how
you want to use the repeater (page 29) ®
.
R Complete the following operations within about 2
minutes.
5
Repeater:
Connect power to the repeater that you want to
register, and then press PROGRAM (A) for about 3
seconds.
R The indicator (B) flashes green.
ID
B
R The indicator lights when the registration is
completed. (Depending on the signal status, the
indicator may not light in green. In this case, see
the repeater's Getting Started.)
6
Main monitor:
Press M N.
Note:
R When using devices in separate buildings or over
long distances, cut outs and image distortions may
not be improved even if a repeater is used.
9.3 Cancelling devices (main
monitor/extension monitor)
1
N ® select "Register/Cancel" ®
M
2
Select "Cancel" ®
3
Select the type of device to cancel
4
Select the device to cancel
.
R A beep sounds and "Cancel completed" is
displayed.
*1 Not displayed when using as an extension monitor.
Important:
R To prevent incorrect operations, remove the
batteries from cancelled sub monitors.
Note:
R When you want to change an extension monitor's
registration number or re-register an extension
A
.
.
*1
®
.
*1 *1
® ®