Magnifying And Searching For Details - ViewSonic PG800X User Manual

Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to
angled projection.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
• Using the remote control
1. Press /
correction page.
2. Press to correct keystoning at the top of
the image. Press
the bottom of the image.
• Using the OSD menu
1. Open the OSD menu and go to the
2. Press Enter.
3. Press to correct keystoning at the top of the image or press
keystoning at the bottom of the image.
The projector can automatically correct vertical keystone. To do this, open the OSD menu
DISPLAY >
and go to the

Magnifying and searching for details

If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
• Using the remote control
1. Press on the remote control to display the Zoom bar.
2. Press repeatedly to magnify the picture to a desired size.
3. To navigate the picture, press Enter to switch to the paning mode and press the
directional arrows (
4. To reduce size of the picture, you can press Auto Sync on the remote control to
restore the picture to its original size. Or you can press Enter to switch back to the
zoom in/out functionality and press
• Using the OSD menu
1. Open the OSD menu and go to the
2. Press Enter. The Zoom bar is displayed.
3. Repeat steps 2-4 in the section of Using the remote control above.
This adjustable range may vary depending on different aspect ratios.
The picture can only be navigated after it is magnified. You can further magnify the picture
while searching for details.
to display the Keystone
to correct keystoning at
DISPLAY >
Keystone > Auto V Keystone and press
, , , ) to navigate the picture.
DISPLAY >
29
/
Press
Keystone > Manual menu.
.
Zoom menu.
/
Press
to correct
/ to select On.