Heat & Glo TRUE-36H-IFT Owner's Manual page 15

- Wait five (5) minutes to allow possible
accumulated gas to clear.
- Set the IFT-ECM 3-position selector switch to ON
or REMOTE position. Module will beep once and
flash a three GREEN LED code on successful
startup.
- If placed in ON position, the appliance will ignite
normally if the error condition was corrected.
- If placed in REMOTE position, use the paired IFT-
RC400, IFT-RC150 or wired wall switch to start
the appliance; appliance will ignite normally if the
error condition was corrected.
- If the IFT-ECM re-enters the lock-out condition
after these steps, call your dealer for service.
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Owner's Manual • 2461-981 Rev. J • 5/18
Appliance ON/OFF:
Your TRUE fireplace is supplied with a fully functional
remote control. This remote controls:
• ON/OFF Functions
• Flame height adjustments
• Thermostat
• Electric Ember Bed
• Cold Climate Feature
• Optional Heat-Zone
®
Please refer to the instructions included with the remote
control for more detailed operating instructions.
Electric Embers
• Electric Embers are a standard feature on all TRUE
fireplaces.
• The intensity of the these lights may be controlled
through the remote control included with your fire-
place.
Optional Heat-Zone
Once the optional Heat-Zone
fied service technician during the appliance installation
process, follow the instruction supplied with the kit for op-
eration.
• Use the RC400 remote to set the Heat-Zone
MED, LO or OFF. The Fan Speed dynamic icon is
used to change the setting. Refer to the RC400 quick
reference guide in section 6.C.
Kit
Gas Kit
®
Kit is installed by a quali-
®
®
to HI,
15