Kohler K-5401X Homeowner's Manual page 9

Important Safety Instructions (Cont.)
Keep pressing the
times. Then change the setting of B/C/E/F/O by the following requirements.
B - Open/close the cover...Sensing distance setting
Long press the key to set up the sensing distance for auto cover-turning:
¨
1. Quick flashing of night light for one time means short-distance (short pip)
2. Quick flashing of night light for twice means mid-distance (short pip).
3. Quick flashing of night light for three times means long-distance (short pip).
4. If the nigh light flickers slowly, turn off the auto cover-turning function (long pip).
C - Seat On/Off...Deodorization function setting
Long press this key to turn on/off the deodorization function.
¨
1. Quick flashing of night light once to activate the deodorization function (short pip).
2. Slow flashing of night light once to deactivate the deodorization function (long pip).
E - Flush-full...Automatic flushing setting
Long press this key to turn off the function of automatic flushing. Long press it again to restore automatic
¨
flushing.
1. Quick flashing of night light once to activate automatic flushing function (short pip).
2. Slow flashing of night light once to deactivate automatic flushing function (long pip).
F - Seat temp...Energy saving setting
Long press the key of Seat Temp to activate the function of energy saving. Long press it again to deactivate this
¨
function.
1. Quick flashing of night light once to activate energy saving function (short pip).
2. Slow flashing of night light once to deactivate energy saving function (long pip).
M -Effuser movement...Effuser cleaning settings
Under non-seating status, long press this key to activate the function of manual cleaning. The nozzle can be
¨
cleaned manually. Long press it again or press Stop key to deactivate this function.
When the setting of B/C/E/F/O is not modified for a certain period, repeat the process that is to keep pressing the
key until a short pip is heard and release the key only after the night lamp flickers for three times before the
next change of setting.
O - UV sterilization (UV light)...Setting of UV automatic sterilization
Long press to set up the on/off status of automatic UV sterilization.
¨
1. Quick flashing of night light once to activate the function of automatic UV sterilization (short pip).
2. Slow flashing of night light once to deactivate the function of automatic UV sterilization (long pip).
Usage and Replacement of Battery for Remote Controller
Charging block of remote controller uses 4 #5 alkaline batteries.
¨
When battery is low, the charging block will flicker in red lamp, hinting
¨
the user that batteries are to be replaced.
Caution:
1. The positive and negative polarities of battery must be consistent with
the mark of remote controller.
2. New and old batteries shall not be mixed.
3. Please use alkaline battery.
Others
□ Do not put the remote control at a place where it may be sprayed by liquid, or immersed in liquid.
□ Do not place it near hand dryer, hair dryer and small size home appliances, to avoid disturbance of normal
usage of the remote control.
□ Do not apply external force to the key zone of remote controller frequently or fiercely.
□ After usage of remote control, put it back into the holder mounted on wall.
□ Prevent dropping the remote control during usage.
□ Anti-theft function: remote controller can be locked and fixed to the base via screws. Refer to the installation
instructions for detailed methods.
Kohler Co.
key until a short pip is heard, and release the key only after the night lamp flickers for three
9
Red Lamp Flicker
1226975-X5-B