Search For Channels; Install Channels; Channel Settings; Channel Installation - Magnavox 55MV387Y Owner's Manual

Hide thumbs Also See for 55MV387Y:
Table of Contents

Advertisement

Search for channels

Be sure the RF cable is correctly connected to this unit and you
are registered with your cable TV provider when you install cable
channels.
1
Press Z and use J K to select Setup then press OK.
2
Use H I J K to select Search for channels, then press OK.
3
Use J K to select Start, then press OK.

Install channels

You can search and store all channels. If you move the unit to a
different area after the initial setting, it is recommended to
perform Autoprogramming.
4
Use H I to select Antenna or Cable, then press OK.
5
Press OK on Start.
When the scanning and memorizing of available channels
is completed, the lowest memorized channel will be
displayed.
6
Follow the on-screen instructions to complete the installation.
System searching. Please
wait...
Auto programming may take
more than 20 minutes to
complete.
1 2
Stop

Channel settings

1
Press Z and use J K to select Setup then press OK.
2
Use H I J K to select Channel settings, then press OK.
3
Adjust the following items.

Channel installation

Installation mode
Child lock
Uninstall channels
Change PIN
Digital audio language
Mono/Stereo
Digital channels found:
0
Analog channels found:
0
Total progress:
3
4
Channel installation
Be sure the RF cable is correctly connected to this unit and you
are registered with your cable TV provider when you install cable
channels.
Installation mode
1
Use H I to select Channel installation, then press OK.
2
Use H I to select Installation mode, then press OK.
3
Use H I to select Antenna or Cable, then press OK.
When Antenna is selected, the TV detects antenna signals.
It searches for DTV and analog TV channels available in your
area.
When Cable is selected, the TV detects signals supplied by
cable. It searches for DTV, analog TV and cable channels
available in your area.
Uninstall channels
The channels selected here can be skipped when selecting the
channels using CH + / –.
Those channels can still be selected with the NUMBER buttons.
1
Use H I to select Channel installation, then press OK.
2
Use H I to select Uninstall channels, then press OK.
3
Use H I to select the channel you want to remove, then press
OK.
The removed channels are not displayed on the list of
favorite channels.
To reactivate a removed channel, use H I then press OK.
36
.
English
Continued on next page.

Advertisement

Table of Contents
loading

This manual is also suitable for:

50mv387y

Table of Contents